[#108]
Re: Gotek - tani emulator fdd
@Norbert,
post #107
Próbowałeś RESETU na podłączonym interfejsie jak to jest opisane na stronie autora wsadu:
NOTE (26/02/14) : If you have some difficulties to make the connection between the device and the software, you can try to issue a reset to the emulator. To do this connect during 1 second the "RST" signal (present at the right of the RX signal) to the ground. Don’t disconnect the RX/TX & Power wires during this operation. Once done start again the software.
Also to make sure that your serial adapter is working correctly, you can try a loopback test : use a terminal software and connect the rx & tx wires of the adapter together : if you get an echo of what you send to the terminal, the loopback test is working !
Wydaje mi się że jak działa ten kabel z hyperterminalem i jest komunikacja z FlyMcu, to kabel jest w porządku. Spróbuj może z mniejszą predkością baud rate, bo gdzieś wyczytałem że te 115200 nie zawsze działa, chociaż tego to nie jestem taki pewien czy na mniejszych wogóle zadziała.